Paper
19 October 2012 Toward the global optimum in zoom lens design
Author Affiliations +
Abstract
After more than a century from the introduction of zoom lenses, the selection of the right zoom lens type for a given specification is still a challenge for the optical designer. In the process of lens design, the optical designer is permanently searching for the best zoom lens structure in order to fulfill the complex balance between weight, cost and optical performance. This is a continuous optimization process and the result is a global optimum. The most important factors influencing zoom lens cost are: the number of spherical and aspherical lenses, the number of moving groups and lenses and finally the group sensitivity to displacement and tilt. Every lens group whether moving or not inside the zoom lens, has a specific complexity and sensitivity behavior dependent on the zoom lens type. It is not obvious which type of zoom lens will optimally satisfy the required specification. This paper describes the selection process exemplary for a zoom lens with a medium focal length range from 28mm to 80mm and a quasi constant f-number (FNO) during zooming. The lens is used mainly for cinematographic applications and must be able to maintain best image position for the entire range of object positions during zooming. Alternative solutions with their advantages and disadvantages are shown, analyzed and evaluated.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Aurelian Dodoc "Toward the global optimum in zoom lens design", Proc. SPIE 8488, Zoom Lenses IV, 848802 (19 October 2012); https://doi.org/10.1117/12.928688
Lens.org Logo
CITATIONS
Cited by 6 scholarly publications and 1 patent.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Zoom lenses

Monochromatic aberrations

Aspheric lenses

Lens design

Relays

Optical design

Distortion

RELATED CONTENT

Design of a wide angle zoom lens using an asphere...
Proceedings of SPIE (September 03 2015)
Dennis Gabor’s catadioptric design and some new variations
Proceedings of SPIE (November 27 2017)
High performance wide angle macrofocus zoom lens for 35 mm...
Proceedings of SPIE (September 21 1998)
Zoom lens design
Proceedings of SPIE (December 14 2001)
Designing Zoom Lenses Aided By The Delano Diagram
Proceedings of SPIE (September 16 1980)

Back to Top