Laser drilling up to 15,000 holes/sec in silicon wafer for PV solar cells

Rahul Patwa; Hans Herfurth; Guenther Mueller; Khan Bui

doi:10.1117/12.2026539

16 September 2013 Laser drilling up to 15,000 holes/sec in silicon wafer for PV solar cells

Rahul Patwa, Hans Herfurth, Guenther Mueller, Khan Bui

Proceedings Volume 8826, Laser Material Processing for Solar Energy Devices II; 88260G (2013) https://doi.org/10.1117/12.2026539
Event: SPIE Solar Energy + Technology, 2013, San Diego, California, United States

Abstract

One approach to realize a back contact solar cell design is to ‘wrap’ the front contacts to the backside of the cell [1]. This results in significantly reduced shadowing losses, possibility of simplified module assembly process and reduced resistance losses in the module; a combination of measures, which are ultimately expected to lower the cost per watt of PV modules. A large number of micro-vias must be drilled in a silicon wafer to connect the front and rear contacts. Laser drilling was investigated using a pulsed disk laser which provided independent adjustment of pulse width, repetition rate and laser power. To achieve very high drilling rates, synchronization of the laser pulses with the two-axis galvanometer scanner was established using a FPGA controller. A design of experiments (DOE) was developed and executed to understand the key process drivers that impact the average hole size, hole taper angle, drilling rate and hole quality. Laser drilling tests were performed on wafers with different thicknesses between 120 μm and 190 μm. The primary process parameters included the average laser power, pulse length and pulse repetition rate. The impact of different laser spot sizes (34 μm and 80 μm) on the drilling results was compared. The results show that average hole sizes between 30 – 100 μm can be varied by changing processing parameters such as laser power, pulse length, repetition rate and spot size. In addition, this study shows the effect of such parameters on the hole taper angle, hole quality and drilling rate. Using optimized settings, 15,000 holes per second are achieved for a 120 μm thick wafer with an average hole diameter of 40μm.

Citation Download Citation

Rahul Patwa, Hans Herfurth, Guenther Mueller, and Khan Bui "Laser drilling up to 15,000 holes/sec in silicon wafer for PV solar cells", Proc. SPIE 8826, Laser Material Processing for Solar Energy Devices II, 88260G (16 September 2013); https://doi.org/10.1117/12.2026539

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available