Paper
27 April 2016 Long period grating response to gamma radiation
Author Affiliations +
Abstract
We report the evaluation of one long period grating (LPG) and one fiber Bragg grating (FBG) under gamma irradiation. The LPG was produced by the melting-drawing method based on CO2 laser assisted by a micro-flame and was engraved in a commercial single mode fiber SMF28 from Corning, grating length 25 mm, grating pitch of 720 μm. After the manufacturing of the grating, the fiber was re-coated with Acrylate and the grating was inserted into special ceramic case transparent to gamma radiation. The FBG is commercialized by Technica SA, and it is written in SMF-28 optical fiber (λ= 1546 nm; grating length of 12 mm; reflectivity > 80 %; bandwidth – BW @3 dB < 0.3 nm; side lobe suppress ratio – SLSR >15 dB; Acrylate recoating). By on-line monitoring of the LPG wavelength deep with an optical fiber interrogator during the irradiation exposure and pauses, both the irradiation induced shift (maximum 1.45 nm) and the recovery (in the range of 200 pm) phenomena were observed. Temperature sensitivity of the LPS was not affected by gamma irradiation.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Dan Sporea, Andrei Stӑncalie, Daniel Neguţ, Sylvie Delepine-Lesoille, and Laurent Lablonde "Long period grating response to gamma radiation", Proc. SPIE 9886, Micro-Structured and Specialty Optical Fibres IV, 98861P (27 April 2016); https://doi.org/10.1117/12.2230233
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Fiber Bragg gratings

Sensors

Optical fibers

Gamma radiation

Remote sensing

Signal attenuation

Physics

Back to Top