Paper
29 June 2001 Laser polishing of GaN
Jan J. Dubowski, S. Moisa, B. Komorowski, Haipeng Tang, James B. Webb
Author Affiliations +
Abstract
The ablative decomposition of GaN films induced with a XeCl excimer laser ((lambda) equals 308 nm) was investigated for a potentially low-damage surface planarization process. Samples, 2-micrometers -thick, were grown on (0001) sapphire by ammonia molecular beam epitaxy. They had a characteristic micro-hillock type surface morphology with a roughness, averaged over 5 x 5 micrometers 2 area, typically, of 13 nm. Following the laser irradiation, this roughness could be reduced to 3.6 nm. The results indicate that the ablation process follows the Lambert-Beer's law, with an absorption coefficient of 3 x 105 cm-1. The experiment was carried out with relatively short pulses ((tau) equals 10 ns), which appear to be responsible for the observed onset of the laser-induced decomposition of GaN and surface planarization at significantly smaller laser fluences than reported in the literature. The ability to carry out decomposition of GaN with low laser fluences is of practical importance for achieving a low-damage GaN planarization process and/or intentional delaminating of this material from the sapphire substrate by the back side irradiation technique.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jan J. Dubowski, S. Moisa, B. Komorowski, Haipeng Tang, and James B. Webb "Laser polishing of GaN", Proc. SPIE 4274, Laser Applications in Microelectronic and Optoelectronic Manufacturing VI, (29 June 2001); https://doi.org/10.1117/12.432536
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Gallium nitride

Laser ablation

Sapphire

Laser irradiation

Excimer lasers

Polishing

Pulsed laser operation

RELATED CONTENT


Back to Top