This work describes an experimental study towards label-free sensing of C-reactive protein (CRP) – a protein recognized as a inflammation marker. A multimode optical fiber with a section of its core coated with indium tin oxide (ITO) thin film was used as a sensor. ITO film allows for guiding lossy modes and can simultaneously be used as a transparent electrode for electrochemical measurements. Therefore, optical and electrochemical detection based on a single sensor was possible. Such a dual-domain approach is practical, especially when the results in one of the domains are not accurate enough, which was the case in this work. A case of different functionalization methods of ITO surface was also pointed out. The proposed sensor allows for recognition as low as ng/mL.
The work discusses the possible impact of the electric charge of biological material on the properties of label-free biosensors, in particular those operating in dual domains, i.e., optical and electrochemical. Optical fiber lossy-mode resonance (LMR) sensors based on indium tin oxide (ITO) were investigated as label-free biosensors with a model biological receptor-target pair, i.e., biotin-avidin. Each of the used biological materials shows different properties, i.e., size, isoelectric point, and, therefore, also charge. The investigations were performed in two electrolytes with differently charged redox couples to better identify the possible influence of chargé of biological material on the optical readout. The obtained results clearly indicate that in designing label-free biosensing solutions, consideration of a broader range of biological materials properties than just refractive index, such as their charge, is required.
This work discuses indium tin oxide (ITO) coated optical fiber lossy-mode resonance (LMR) sensor working in an electrochemical setup for monitoring of protein binding to the sensor’s surface. The binding mechanism has been observed simultaneously in optical and electrochemical domain. The combined measurement was enabled by the electrically conductive ITO overlay. In the experiment, biotin molecules have been used to test the collective optical and electrochemical setup and to illustrate the binding effect. It has been shown that the effect is observed in the investigated domains at applied potential, and the qualitative comparison shows high resemblance of the outcome.
This work presents an optical fiber sensors based on lossy–mode resonance (LMR) phenomenon supported by indium tin oxide (ITO) thin overlay for investigation of electro-polymerization effect on ITO’s surface. The ITO overlays were deposited on core of polymer-clad silica (PCS) fibers using reactive magnetron sputtering (RMS) method. Since ITO is electrically conductive and electrochemically active it can be used as a working electrode in 3-electrode cyclic voltammetry setup. For fixed potential applied to the electrode current flow decrease with time what corresponds to polymer layer formation on the ITO surface. Since LMR phenomenon depends on optical properties in proximity of the ITO surface, polymer layer formation can be monitored optically in real time. The electrodeposition process has been performed with Isatin which is a strong endogenous neurochemical regulator in humans as it is a metabolic derivative of adrenaline. It was found that optical detection of Isatin is possible in the proposed configuration.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.