40P2O5-20Al2O3-(30-x)Na2O-10BaO-xEr2O3 (PANB) glasses with different Er3+ concentrations were fabricated by the traditional melt quenching method and their spectroscopic properties were investigated. Glass thermal stability is investigated by differential scanning calorimetry (DSC) (Tx-Tg=138°C) which indicates a better recrystallization performance than that of fluorophosphates glass and fluorotellurite glass. The derived Judd-Ofelt intensity parameters of Er3+ doped PANB glass (Ω2=18.8, Ω4=15.9, Ω6=5.38(×10-20cm2 )) indicate higher asymmetry and stronger covalent environment when compared with Er3+ doped tellurite, fluoride and fluorotellurite glasses. Compared with Er3+ transitions in other glass hosts, large stimulated emission cross-section and broad full wave at half maximum (FWHM) were found to be 4.58×10-20cm2 and 60 nm centered at ∼1550 nm, respectively. It implies a potential material for infrared lasers and amplifiers.
Active resonators based on optical waveguides can significantly enhance the performance of optical gyroscope due to its loss compensation effect. The spontaneous emission noise (SEN) stemmed from optical gain will broaden the linewidth of the resonator and limit the sensitivity and resolution of active resonator optical gyroscope (AROG). In this paper, we modified the sensitivity formula when the spontaneous emission noise is dominant and analyzed theoretically the performance limitations of the AROG. After considering the spontaneous emission noise source, the resolution can be improved through optimizing the design parameters of the AROG
We theoretically analyze the characteristics of scale factor in frequency sensitive integrated optical gyroscope consisting of a ring resonator coupled with double ring resonators. The impact of through coupling coefficients is investigated to decide the optimal parameters located at 0s-1 for improving the scale factor. It demonstrates that the scale factor enhancement in this frequency sensitive optical gyroscope, without increasing the overall footprint, can be improved compared with conventional single ring resonator gyroscope and presents the characteristic of better performance within low-rate range. It implies a broad prospect in highly integrated on-chip applications, especially in aeronautic and astronautic area.
In this paper, an active ring-coupled Mach-Zehnder interferometer (arcMZI) for rotation sensing is proposed. Theoretical resolution formula of this arcMZI gyroscope was deduced by using of transfer matrix method and noise analysis model. The simulation result shows that the theoretical maximum sensitivity of arcMZI gyroscope can be enhanced at least two orders of magnitude compared with the single-bus resonator (SBR) gyroscope for the same footprint and effective loss after equivalent optimization. The arcMZI gyroscope could be of great potential to meet the tactical demands of future inertial navigation.
Optical waveguide is used in most integrated optic devices to confine and guide light in higher refractive index channels. The structures and materials of slot waveguides are reviewed in this paper. Coupled resonator optical waveguides (CROWs) can be used for a rotation sensor with compact size, low power consumption and low cost. The loss determines the ultimate sensitivity of CROW gyros. Resonator-based optical gyroscope’s sensitivity for measuring rotation is enhanced via using the anomalous dispersion characteristic of superluminal light propagation, which can be also generated by using passive optical resonators.
KEYWORDS: Gyroscopes, Resonators, Waveguides, Active optics, Signal to noise ratio, Phase shifts, Signal attenuation, Optical engineering, Interference (communication), Glasses
We propose and analyze a gyroscope using active three-dimensional vertically coupled resonators (3D-VCRs), which allows for loss compensation, unidirectional propagation, and a larger sensing area while maintaining the same bulk volume. For the ideal uniform case, the minimum detectable rotation rate ΔΩmin of the active 3D-VCR gyroscope can be decreased by above three orders of magnitude after optimization compared with the passive case. The minimal measurable rotation rates of the 3D-VCR gyroscope, the loss-compensated coupled resonator optical waveguide (LC-CROW) gyroscope, and the equivalent resonant waveguide optical gyroscope (RWOG) decrease with a higher number N of the resonators. Finally, it is shown that the uniform active 3D-VCR gyroscope has a better resolution ΔΩmin than the equivalent LC-CROW and RWOG.
KEYWORDS: Gyroscopes, Resonators, Waveguides, Active optics, Signal to noise ratio, Wave propagation, Glasses, Phase shifts, 3D modeling, Refractive index
Active coupled resonator optical waveguide (CROW) structure can significantly enhance the performance of optical gyroscope due to its loss compensation effect and highly dispersive properties. In this paper, we analyze the effect of optical gain and its induced noise, i.e. spontaneous emission noise, on the properties of the active CROWs. A thorough investigation of the impact of various disorder degrees on the performance of the active three dimensional vertically coupled resonators (3D-VCR) gyroscope has been performed. It shows how the disorder interacted with coupling coefficient affects the achievable resolution ΔΩmin of gyroscope, and the degree of disorder will supplant the propagation loss to become an ultimate limitation. Finally, it is shown that the active 3D-VCR gyroscope (the number of ring, N>6) has better resolution ΔΩmin than that of the equivalent resonant waveguide optical gyroscope (RWOG).
We propose a configuration consisting of several passive ring resonators named as fast-light
enhanced ring resonator, coupled to an active ring laser for introducing anomalous dispersion.
Theoretical analysis indicates that the introduced anomalous dispersion allows the frequency shift to
be improved as large as one order of magnitude due to Sagnac effect when the structure is rotated,
namely having the same rotational sensitivity compared to a standard ring-laser gyroscope (RLG)
with tenfold size as that of the proposed structure. In this paper, the impact of passive ring resonator
number is discussed and deduced, which manifests that only odd number of passive rings will
produce effective anomalous dispersion, thus improve the rotational sensitivity. The configuration
proposed here will have broad prospect in realizing highly integrated on-chip laser gyroscope for
rotation sensing.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.