Paper
17 May 2010 Laser-assisted chemical etching for texturing silicon surface
Mitsunori Saito, Saori Kimura
Author Affiliations +
Abstract
Alkaline etching of silicon surfaces was studied to make anisotropic microstructures. An aqueous solution of potassium hydroxide was used as an etchant. The etching rate of silicon was heavily dependent on crystal orientation and temperature; i.e., the etching rate for the (100) surface was four times larger than that for the (111) surface, and they both increased by ten times as temperature rose from 25 to 60 °C. A laser beam was irradiated to a silicon surface to create a temperature distribution that realized selective etching. A pulsed green laser (532 nm) of 5 ns duration was used as a light source to enhance temperature difference between irradiated and nonirradiated portions. By passing through a photomask and an imaging lens system, the laser beam created an optical power distribution on a silicon plate dipped in an etchant. Depending upon the mask pattern, a groove array or a two-dimensional pit array was created on the silicon surface. These pits took a rectangular shape on the silicon (100) plate, while they took a triangular or hexagonal shape on the (111) plate.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Mitsunori Saito and Saori Kimura "Laser-assisted chemical etching for texturing silicon surface", Proc. SPIE 7719, Silicon Photonics and Photonic Integrated Circuits II, 77191I (17 May 2010); https://doi.org/10.1117/12.853764
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Silicon

Etching

Wet etching

Semiconductor lasers

Photomasks

Chemical lasers

Glasses

Back to Top