Paper
5 September 2014 Thermal expansion properties of thin multilayer films
Author Affiliations +
Abstract
Under synchrotron radiation white beam exposure, strong mechanical stress can build up in multilayer optics, caused by the thermal mismatch between layer material and substrate material. To study the stability and performance of multilayer optics under heat load, Pd, Cr, and B4C single layers of thicknesses in the nanometer range and [Pd/B4C] multilayers were prepared in the sputter-depositing facility of the ESRF Multilayer Laboratory. Curvature changes versus temperature were measured using a Shack-Hartmann wave front sensor. Films coated on 200 μm thin Si wafers induced significant curvature changes over a temperature range from 60°C to 200°C. A combined parameter K including Young’s modulus and thermal expansion coefficient (CTE) was defined to describe the thermal deformation properties of the thin-film layer. The investigation shows that all three materials in thin film cause less thermal expansion than expected from material properties for bulk material in the literature. In particular, the thermal expansion of B4C films appears to be close to that of the Si substrate.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Xianchao Cheng, Christian Morawe, Jean-Christophe Peffen, and Lin Zhang "Thermal expansion properties of thin multilayer films", Proc. SPIE 9207, Advances in X-Ray/EUV Optics and Components IX, 920709 (5 September 2014); https://doi.org/10.1117/12.2059583
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Palladium

Multilayers

Thin films

Temperature metrology

Silicon

Chromium

Semiconducting wafers

Back to Top