This will count as one of your downloads.
You will have access to both the presentation and article (if available).
Laser phosphor projection sources enable a cost effective way to generate high light flux, since they take advantage of the recent cost down of blue laser diodes and do not need to use expensive green and red lasers. The primary colors are e.g. generated by blue laser diode illuminating a phosphor wheel to create yellow light. The yellow light is subsequently split into green and red light by means of e.g. a dichroic filter. With increasing light flux standard phosphor wheels that are based on a phosphor embedded in silicone, degrade at high peak temperatures. Wheels with a ceramic phosphor have a much higher temperature stability and offer a significant improvement. This paper discusses the requirements on optical materials used for digital projection.
Femtosecond laser radiation in the near UV wavelength range generates solarization effects in optical glasses. In this paper results are shown of femtosecond laser solarization experiments on a broad range of optical glasses from SCHOTT. The measurements have been performed by the Laser Zentrum Hannover in Germany. The results and their impact are discussed in comparison to traditional HOK-4 and UVA-B solarization measurements of the same materials. The target is to provide material selection guidance to the optical designer of beam shaping lens systems.
Additionally the mirror blanks need to be dimensionally stable for more than 30 years. In particular, stress effects due to the changes in the environment shall not entail shape variation of more than 0.5 μm PV within 30 years.
In 2010 SCHOTT developed a physically based model to describe the thermal and mechanical long time behavior of ZERODUR. The model enables simulation of the long time behavior of ZERODUR mirror blanks under realistic mechanical and thermal constraints. This presentation shows FEM simulation results on the long time behavior of the ELT M1, M2 and M3 mirror blanks under different loading conditions. Additionally the model results will be compared to an already 15 years lasting long time measurement of a ZERODUR sample at the German federal physical standardization institute (PTB).
In recent years SCHOTT pushed the push rod dilatometer measurement technology to its limit. With the new Advanced Dilatometer CTE measurement accuracies of +- 3 ppb/K and reproducibilities of better 1 ppb/K have been achieved. The new Advanced Dilatometer exhibits excellent long time stability.
SCHOTT has a long experience in producing and delivering large optical glass blanks for astronomical applications up to 1 m and in homogeneity grades up to H3 quality in the past.
The most common optical glass available in large formats is SCHOTT N-BK7. But other glass types like F2 or LLF1 can also be produced in formats up to 1 m. The extremely large telescope projects partly demand atmospheric dispersion components even in sizes beyond 1m up to a range of 1.5 m diameter. The production of such large homogeneous optical glass banks requires tight control of all process steps.
To cover this demand in the future SCHOTT initiated a research project to improve the large optical blank production process steps from melting to annealing and measurement. Large optical glass blanks are measured in several sub-apertures that cover the total clear aperture of the application. With SCHOTT's new stitching software it is now possible to combine individual sub-aperture measurements to a total homogeneity map of the blank. In this presentation first results will be demonstrated.
Unfortunately the chemical composition of those glasses leads to a high coefficient of thermal expansion, low hardness and low resistance against chemical attacks. As a consequence these glasses tend to be difficult in processing. Therefore the glass engineer’s task is to improve processing characteristics while keeping their special optical properties. N-FK58 XLD is an example of a new generation of XLD glasses from SCHOTT with improved workability. In 2014 a processing study has been conducted to optimize the polishing of XLD glasses. This presentation will show the results of this study for N-FK58 XLD and the application to other fluorophosphates glasses.
View contact details
No SPIE Account? Create one
