A series of AlAsSb p+-i-n+ and n+-i-p+ diodes with varying i-region thickness from 0.08μm to 1.55μm have been used to determine the temperature dependent impact ionization coefficients by performing avalanche multiplication measurements from 210K to 335K. The increase in electron and hole ionization coefficients as the temperature decreases is much smaller when compared to InAlAs and InP. This leads to a much smaller avalanche breakdown variation of 13mV/K in a 1.55μm p+- i-n+ diode. For a 10Gb/s InGaAs/AlAsSb separate absorption and multiplication avalanche photodiode (SAM-APD), the variation in breakdown voltage is predicted to be only 15.58 mV/K.
This paper presents the electron and hole avalanche multiplication and excess noise characteristics based on bulk AlAs0.56Sb0.44 p-i-n and n-i-p homojunction diodes lattice matched to InP, with nominal avalanche region thicknesses of 0.6 -1.5 μm. From these, the bulk electron and hole impact ionization coefficients (α and β respectively), have been determined over an electric field range of 220-1250 kV/cm for α and from 360-1250 kV/cm for β for the first time. Excess noise characteristics suggest an β/α ratio as low as 0.005 for an avalanche region of 1.5 μm in this material, close to the theoretical minimum and significantly lower than AlInAs, InP, or even silicon. This material can be easily integrated with InGaAs for networking and sensing applications, with modeling suggesting that a sensitivity of -32.1 dBm at a bit-error rate (BER) of 1×10-12 at 10 Gb/s at 1550 nm can be realized. This sensitivity can be improved even further by optimizing the dark currents and by using a lower noise transimpedance amplifier.
AlAs0.56Sb0.44 is a promising avalanche material which can be grown lattice-matched to InP and therefore use InGaAs as the absorption region in a Separate Absorption and Multiplication APD (SAM-APD). The electron and hole ionisation coefficients in this material are very dissimilar and our experiments show that this leads to AlAs0.56Sb0.44 having the lowest excess noise performance of any InP based material system (F = 2.2 at M = 40) reported to date. Simulations suggest that operation at 1550 nm and 25 GB s-1 with a sensitivity of -25.7 dBm is possible in a normal incidence SAM-APD.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.